How to Resolve dell printer error 092-673 – Technology evolves in lockstep with the passage of time. Professionals are always inventing and developing new printing processes and printers. Among all, Dell is the most famous and dependable brand that manufactures high-quality printers that provide consumers with a pleasurable printing experience.

The added value and quality of these printers are lauded by users worldwide. It is an electronic gadget, and electronic devices are prone to malfunction, one of which being Error Code 092-673. If you’re looking for information about How to Fix Dell Printer Error Code 092-673, you’ve come to the correct spot.
While Dell printers are well-known for their low-cost printing and high-quality output, users have sometimes experienced technical troubles with them, such as Error Code 092-673.
These inaccuracies may be both vexing and aggravating. This mistake is often referred to as calibrating patch errors, and they are rather prevalent with a few Dell printer models. If you are a victim of this and are looking for information on How to Fix Dell Printer Error Code 092-673, you have come to the right place. We are professionally qualified specialists, and via this blog, a Tech Support expert will explain how to simply address this problem.
Steps to Troubleshoot Dell Printer Error Code 092-673
Dell printers are renowned for their high-speed printing, cheap cost, and high-quality output. These printers are among the finest in the world, providing users with an exceptional printing experience. One may print a great deal with a little payment. However, a single error code, 092-673, spoils the whole printing experience and has a negative influence on the consumers. This is a typical mistake that is sometimes referred to as calibrating patch errors. Fortunately, there are a few simple procedures that may be taken to address this problem. Therefore, if you are experiencing this issue, please follow the procedures below.
Method 1: Eliminate ROS
To prevent a reduction in print quality caused by strains within the Dell printer, it is necessary to frequently clean the Dell printer from the inside. Simply clean the printer carefully with a cleaning bar while changing the drum cartridges.
To execute this procedure, follow these steps:
- Open the spread on the right and left.
- Turn the toner box lock about 90 degrees counterclockwise to access the waste toner box.
- Once complete, take a firm hold on the waste toner box and pull it straight out of the box, being careful not to spill the waste toner box.
- By standing upright on a flat surface, remove the waste toner box.
- Remove the cleaning bar from the printer’s inside.
- Insert the clearing bar into any of the four apertures until it clicks and totally pulls out.
- Rep the previous step in the last three slots. One minute is sufficient for each opening.
Method 2: Ensure that the CTD sensor is clean
Cleaning the CTD sensors is the second way for resolving Error Code 092-673. To execute this procedure, follow the steps outlined below:
- The first step is to ensure that your Dell printer is totally switched off.
- The next step is to open the rear cover by pressing the latch downward.
- Now, on the right-hand side, lift the lid.
- Once opened, unlock the waste toner box by rotating the lock lever counterclockwise 90 degrees.
- Now, take out the waste toner box while holding the box’s handle. Take care with this and ensure that it remains upright during the procedure to prevent leaking waste toner.
- Arrange the box upright on a flat surface.
- Open the printer’s operating panel and raise the topmost cover.
- Put your fingers in the loops of the transfer belt and slowly pill it out.
- Finally, wipe the CTD sensor with dry cotton or a towel.
Conclusion:-
I hope the above steps help you to fix the dell printer error 092-673, just follow the above steps to fix the issue in just few steps